Monday to Thursday 10 am to 5 pm ET & Friday 10 am to 4 pm ET
MSRP: $19.99 (30cc); $21.99 (48cc and 50cc); $23.99 (60cc)
Cartridges will last indefinitely but should be replaced with the first sign of rust or surface deterioration.
Each jacket comes with a handy tool to complete the replacement quickly and...
One Coiled Wire is included with each Hit Air vest or jacket.
Additional units are available for those who have more than one motorcycle.
RS-1 (Racing Motorcycle)
To be attached to the motorcycle and connected to the...
Every airbag vest and jacket comes with one tool kit, if you misplaced or lost it you may buy one or more extra tool kits. The bolt must belong to the Hit-Air kit, as any slight difference in the diameter of the bolt may cause damage overtime in the...
Hit Air accessory: Saddle Strap.
A saddle holder is required to be attached to the saddle.
It comes in three lengths: 20 inches, 19 inches or 17 inches. (Select above your length).
Please see below instructions:
How to tie the coiled wire...
Replacement part for keybox.
How To Replace Red slide on Key box
Step 1) Remove CO2 canister, then remove key ball using the hex wrench to turn the bolt slightly to ease the pressure of the spring to make it easier to remove the key ball...
Buckle extender adds up to 7" to the chest belt and up to 6.25" to the waist belt.
The buckle extender can be adjusted to better fit your needs.
Works on all the harness models: SV2, LV, MLV, and Advantage.
Please select the needed model above...
To stop dangling of the coiled wire while not in use.
Key wire (ring) - 42mm diameter/15cm length Binding wire (black) is supplied with the Hit-air
All Hit-Air extra protectors are designed to improve the response to an impact, even though the airbags will absorbe most of it there are circumstances that will greatly benefit from the use of a chest or back protector, like previous...
A set of a key ball and a buckle type female connector to connect/disconnect with a buckle type coiled wire now in use.
Use as the replacement for the damaged of lost set.
There are two types of Key-Ball-Sets replacements. B-Type is for 50cc and...
To be attached to side-belts of the harness type all-in-one airbag.
The combination of side padding and the hit-air system brings about a greatershock-buffering effect.
Size: W230mm X H145mm X D20mm
Material: Main body / Polyethylene...
S-System is an improved key box (a device to activate the airbag system) cutting the deployment time (from activation to full inflation of the airbag) in half.
Deployment in about 0.25 sec !
This replacement is only for some MODELS OLDER than 2010...
OPTIONAL back padding. Attaches with an already installed velcro to the Hit-Air vest or jacket.
Designed to spread the impact.
Synergy between CE back padding and the Hit-air system will produce a greater shock buffering effect.
Size: Width= 6.8"...
Carrying Tote bag for your Airbag Vests, take your extra canisters, toolkit, jacket, bottle of water, cell phone and more all in one place.
Each Tote features a main zippered compartment and a front zippered pocket with a full interior...
The Loop Setter is an accessory part for the Coiled Wire.
It is used to attach a coiled wire to your saddle or motorcycle.
Soft Velcro to be sewn onto the wear other than hit-air is supplied with the hit-air.
To attach to any other jacket or vest, sew the Velcro (female)- supplied with the hit-air-onto it.
Size: Width=4.7" X Height= 8.6" (W 120mm X H 220mm)
All Hit-Air extra protectors are designed to improve the response to an impact, even though the airbags will absorb most of it there are circumstances that will greatly benefit from the use of a chest or back protector, like previous...
Suitable for the mesh jacket as its lining.
As the lining of high resistance to cold and wind, it makes the mesh jacket wearable in any season.
Moisture permeable and waterproof material of "INTERON" is used for light, soft and comfortable inner...
back, chest and side protectors are attached to the harness and secured to the rider
used to secure body armor under the SV2 and LV models
can be used as stand alone body armor once padding is secured
Color: Black (picture shows yellow for...
hollow structure to disperse shock
shorter, more narrow torso size
Protects ribs and vital organs on or off the bike or horse
Velcro strips attach to any air vest or jacket
can be used with a stand-alone...
This product is COVER ONLY
While inside of this Velcro Cover, the CE Back Padding can be used with:
air vests and jackets with velcro tabs for back padding
air vests and jackets with an inner pocket for back padding
a stand alone...
Memory Elastan material (Shape-memory cushion) Conformance to EN1621-2 level 2
Recommended for any Hit-Air vest or jacket with a pocket for back padding.
Light, soft and comfortable inner pants.
Moisture permeable and waterproof material of “INTERON” is used to improve waterproof, windbreak and cold protection.
Draping of knees takes riding posture into account
Material: Outshell :...